Don’t put it in rice! This is what you should do if you drop your cell phone in the water – Teach me about Science

Do not get carried away by easy tips, here is the correct way to save your mobile.

Smartphones have become an indispensable tool today, and surely your heartbeat speeds up when you see your mobile swimming. Although several companies currently offer waterproof devices, there is a possibility that if you drop your phone in water it will be damaged, especially if you do not know what to do. Do not get carried away by easy tips, here is the correct way to save your mobile.

First, let’s see what you should not do
  • Don’t bury it in grains of rice. An old trick says that submerging the mobile in grains of rice helps you remove moisture, but it is not as effective as they say, and it can even aggravate the problem. Starch in grains and smaller particles can get into the phone’s openings, and you don’t want to have another problem.
  • Do not put it in the sun to dry, as the heat can damage the internal components.
  • Don’t even think about using a dryer (such as a hair dryer), the force of the air can push the water into smaller openings where it is very difficult or impossible to remove.
  • Do not connect your phone until you are completely sure that it is dry. Attempting to use or charge the phone may cause a short circuit.
How to save your phone if you drop it in the water?
  1. Take it out of the water. You should do this as soon as possible and dry it briefly with a clean, dry cloth.
  2. Turn it off. If it’s on, turn it off. This can prevent short circuits from damaging the device.
  3. Remove everything you can remove. Remove the phone from its protective case. If possible, also remove the SIM card, battery, and micro-SD card. Here you can also use a clean dry cloth to lightly wipe and dry it.
  4. Shake it. Gently shake the phone to remove any water from the connectors. Gently tap the device port side down to shake off excess fluid.
  5. Dry the outside. Dry it with a dry cloth or with small paper napkins to remove all the outer water. It is recommended to use a microfiber towel to dry as best you can.
  6. Let it dry. You can put it in an airtight container with silica gel packets (as many as you can) for 24-48 hours. If you do not have this option, simply let it dry on a towel, try to do it in an environment without dust or strong air currents.
  7. Turn on again. After you have waited two days, you can try to turn it on and see if it works. If at this point it doesn’t work, it would be best to take it to a specialist and avoid handling it on your own.
Additional Recommendation

It is very important to know that it is not a good idea to manipulate the inside of a cell phone if you do not know enough to do it. Doing this could make the situation worse, cause a new problem, or void your warranty if you have one.

If at first glance you see that the damage is serious, then it might be best to seek the help of a specialist. Similarly, if you find that the phone still has watermarks after performing the above steps, consider taking it to a repair shop where they can take it all apart and dry it completely.

Share science, share knowledge.

Source link

About John

Check Also

From a 13-inch tablet to a 17-inch slider

Leave a Reply

Your email address will not be published.